Rubber Light Outsole Introduction 輕質大底
鞋子除了外觀及功能性考量外,鞋子的舒適性越來越受到消費者的重視,除了穿著的舒適性外,鞋子的輕量化,一直是鞋業界追求的目標,而橡膠底的輕量化,更扮演重要的角色。
Beside the appearance and function of footwear, the perception of comfort is more and more important for customers during wearing and will influence their purchase willing .
§ 可生產有邊牆之大底, 底部底花不超過2m/m厚之隔色作業(生產多色大底) 。
§ 經設計後之底模可生產RUBBER LIGHT 牆/RUBBER底,可維持底部耐磨的物性,且達到輕量的目的。
§ RUBBER LIGHT的模具開製與一般橡膠模的開製方法相同。
§ 整體性質、外觀與橡膠大底相同,不會有類似EVA或PU外觀,產生氣孔的問題。
§ 成本不高於RB+EVA 、 RB+PU 或直接PU之OUTSOLE 。
• Can be used for the outsole with sidewall and multicolor.
• Can be used for the outsole with RUBBER LIGHT sidewall and RB bottom, so can remain the characteristic of RB, especially in wear-resist performance and reach the goal of outsole lightening.
• The mold for RUBBER LIGHT is same as traditional rubber mold.
• The quality and appearance are the same as traditional outsole. No more pore cell on the surface happened in EVA or PU.
• The cost is not higher than the outsole of RB+EVA, RB+PU, or only PU.
輕質大底為目前市面上較罕見的比重小于1而介於0.88-0.9之間,并可浮于水面上,且不完全靠發泡,而以1:1在模具上作業,重量輕于以全橡膠制作大底的15%左右之輕質材料,亦可搭配如耐油,止滑,抗靜電等功能來制造,該項輕質大底自2003年開發完成到今已生產近877萬雙。
Rubber Light Outsole is rare in the market, the Specific Gravity is less than 1 and between 0.88 to 0.9, can be float in water, but not quite foaming, with 1: 1 mold operation, the weight is about 15% lighter than regular rubber, and rubber light also can produced with the function of oil resistant, slip resistant, static-resistant, it has been produced 8,770,000 pairs since 2003.